Jim's Email Jim's Web Site
| January 19 | July 19 |
| February 19 | August 19 |
| March 19 | September 19 |
| April 19 | October 19 |
| May 19 | November 19 |
| June 19 | December 19 |
Go to 2011
Go to 2012
Go to 2013
Go to 2014
Go to 2015
Go to 2016
Go to 2017
Scroll down For Today and this Month
___________
1/20/2020
Handle for Vice
___________
1/19/2020
Finished Vice for Cut Off Saw
____________
1/18/2020
82 Hours without Power, Played with Ball Screw
___________
1/17/2020
Still No Power
____________
1/16/2020
Snow No Power
____________
1/15/2020
Vice almost done for cut off saw.
_______________
1/14/2020
Radio Class
____________
1/13/2020
Pivot Blocks Mounted, they need to have corners with radius.
____________
1/12/2020
Pivot Blocks and Shaft made.
___________
1/11/2020
Started Arbor
___________
1/10/2020
Bearing Blocks for Cut Off Saw.
___________
1/09/2020
After much deliberation, I picked the material to make a abrasive cut off saw.
___________
1/08/2020
All Day
___________
1/07/2020
Radio Class
____________
1/06/2020
Clean up, and fix broken stuff.
___________
1/05/2020
This what the Sine Plate was designed to do. The triangles that convert the sine plate to angle plate have a 90º corner.
I milled the opposite side to 45º. Now I can use them for 45º or 90º. Used precision blocks to set Sine Plate.
____________
1/04/2020
Finished first set of side clamps Zero to 34 Degrees, for Sine Plate.
____________
1/03/2020
Cut and Milled to length support bars for Sine Plate
____________
1/02/2020
Cut and Milled to length sides for Sine Plate
____________
1/01/2020
